Instruction manual TREJON OPTIMAL UPX plough (2010)
17
1.11 Cutting angle
– adjustment
The default cutting angle is 15° (Z = 420 mm)
– see Figure 19. In general, cutting angles only need to
be adjusted after the springs have been replaced
– see section 1.12.
Dimension Z
– see Figure 19 – can be used as a control measure. By tightening the nut (M) in the
upper part of the spring rod (P), the cutting angle is smaller
– for cutting angle 0°, Z = 390 mm.
Loosening the nut (M) makes the angle larger.
M
P
Figure 19
