ENGLISH
ENGLISH
6
7
6.
Connect the B end of the Y cable to the battery connector.
7.
Tuck the excess Y cable (B end) behind the rear battery
mount in the base of the down tube.
8.
Route the rest of the Y cable (A end) over the top of and
behind the motor.
Install the Range Boost Battery Mount
1.
Remove the three water bottle cage bolts (4mm) and the
round rubber plugs from the down tube.
2.
For each of the three holes in the Range Boost Battery
Mount, use (in order) the three bolts, spacers, and o-rings
to create the Range Boost Battery Mount assembly.
BOLT
O-RING
SPACER
NOTES:
There are three spacers included in the Range
Boost bag of contents for carbon frames. Carbon frames
will need spacers between the Range Boost Battery
Mount and the frame to prevent surface damage to the
bike frame.
The o-rings act as a retention system to keep the
spacers and bolts in place on the mount.
3.
Place the Range Boost Battery Mount assembly on the
down tube with the holes lined up.
4.
Screw this plunger bolt (circled) out to decrease the lock
travel with RIB installed. Screw this plunger bolt in if the
lock impedes installation of the RIB battery.
