9
User manual
7.
Operating the TrekStor SmartTV Station
7.1
General operation
Switching the SmartTV Station on/off
If the SmartTV Station is connected to the grid, you can put it into standby mode
respective put into operation again by using the STANDBY button on the remote
control or the main switch on the device itself. To switch the SmartTV Station
completely off, you must disconnect it from the grid.
Please note that the boot process may take up to 1 minute. The duration of
the disconnection process may take up to 15 seconds. The LED on the opera-
ting mode display lights red
.
Please note: If the SmartTV Station is connected to a network, the portal
appears after turning the device on. If there is no initial network connection,
the startup screen appears first.
7.2
Adjusting the volume
You can raise or lower the volume by pressing the VOL+ or VOL- button on the
remote control. If you keep the VOL+ or VOL- button pressed, the volume changes
constantly. To mute the sound, please press the MUTE button.
Summary of Contents for SmartTV Station
Page 1: ......