Trelawny A45, Operation And Maintenance Manual

RECOMMENDED PARTS AND FAULT FINDING

Machine Storage

Remove  the  filter  and  clean  it,  replace  with  fresh  ENDLESSBAG  section  and  store  the  vacuum  cleaner  in  a  place 

protected against condensation and at a temperature between 0°C and 40°C.

Cover with a nylon sheet to prevent accumulation of dust.

Scrapping

In  case  of  scrapping,  all  the  component  parts  of  the  vacuum  cleaner  will  have  to  be  disposed  of  through  adequate 

disposal channels in accordance with applicable legislation.

Before scrapping, all plastic and rubber parts will have to be separated from the electrical material.

Most parts made from plastic, aluminium, copper or steel are suitable for recycling.

FAULT

CAUSE

ACTION

The cleaner fails to 

start.

No power.

Check the power mains supply.

Check the integrity of the plug and power 

cable.

Thermal magnetic switch tripped

Reset the thermal magnetic switch.

Loose wiring, incorrect voltage, or blown 

fuse.

Check connections and power supply or 

replace fuse.

Dust is leaking out 

Perforated vacuum pipe.

Replace the pipe.

Perforated filter.

Replace the filter.

Filter unsuitable for type of job.

Fit a suitable filter for the type of material to be 

vacuumed.

The vacuum cleaner 

does not work as it 

should.

Pipe perforated or blocked.

Check the pipe and, if necessary, replace.

ENDLESSBAG Section full

Replace ENDLESSBAG Section.

Filter blocked.

Replace filter.

Seals worn.

Clean the filter and if necessary change it.

Air leak.

Check for any air leaks out of closing 

fasteners, tightening screws, Hopper or filter 

chamber.

If problem has not been cured by any of the above actions, contact your local Trelawny SPT dealership for assistance.

PART NUMBER 

DESCRIPTION

303.5282

Polyester Filter with 14 Pockets 20000 CM

2

 Ø500

303.5289

Filter

-

Holder Seal Ø500

303.5493

Filter Clamp Ø500

303.5770

ENDLESSBAG bag (4 x 20m)