Trend Micro™ Network VirusWall™ Enforcer 2500 Administrator’s Guide
5
-
6
To run the rescue utility from the CD:
1.
Insert the Trend Micro Solutions CD for Network VirusWall Enforcer 2500 into
your CD-ROM drive. The autorun program loads.
2.
Select
Network VirusWall Enforcer 2500 Appliance Firmware Flash Utility
from the menu on the left.
3.
Click
Launch
to run the utility.
To upload with the utility:
1.
To use the most up-to-date program file and boot loader, download them from the
following Website to your computer:
http://www.trendmicro.com/download
. Locate the Network
VirusWall Enforcer 2500 files.
Otherwise, use the program file with factory defaults and the original boot loader
located on the
Trend Micro Solutions CD for Network VirusWall Enforcer 2500
.
2.
Configure the computer to use a static IP address in the range 192.168.252.2 to
192.168.252.254 with a subnet mask 255.255.255.0.
Note:
If you are running PC-cillin
™
2002 or later, set the Personal Firewall settings
to "low" or "medium" when using the utility.
3.
Enter rescue mode (see
4.
Connect one end of the included crossover Ethernet cable to your computer’s
LAN port and the other end to port
5
of the Network VirusWall Enforcer 2500
device.
5.
Run the program from your computer or from the CD.
6.
If the utility has not yet detected the Network VirusWall Enforcer 2500 device,
click
Detect
on the toolbar menu. The utility detects the Network VirusWall
Enforcer 2500 device connected to the computer and lists it in the detection table.
7.
Click the first row to select the detected device from the detection table.
8.
Click
Flash DOM
. The Flash screen appears.
9.
On the Flash dialog box, perform the following:
a.
Click
Browse
and locate the file boot loader file (.B file).
b.
Click
OK
.
