Configuring Policy Enforcement and Device Settings
2
-
25
5.
Type the
IP address
and
Subnet mask
under
Bridge IP Settings
.
6.
Select the
Port
and
VLAN ID
checkboxes under
Bound To
.
7.
Click
Save
.
To configure the Static Routes settings:
1.
Click
Administration
. The drop down menu displays
2.
Click
IP Address Settings
from the drop down menu. The
IP Address Settings
screen displays.
3.
Select the
Static Routes
tab. The
Static Routes
screen displays.
4.
Click
Add
. The
Add Static Route
screen displays.
5.
Type the
Network ID, Netmask,
and
Router
under
Static Route Settings
.
6.
Select the
Interface
under
Bound To
.
7.
Click
Save
. The
Static Routes
screen displays.
Configuring LDAP Settings
Configure LDAP settings from the Web console.
LDAP setting considerations:
•
If you select Kerberos as the authentication method, ensure you fill out the KDC
settings and that the device and LDAP server times match.
•
If you select Simple as the authentication method, the password for Network
VirusWall Enforcer 2500 and the LDAP server is not encrypted.
To configure LDAP server settings:
1.
Click
Administration
. The drop down menu displays
2.
Click
LDAP Settings
from the drop down menu. The
LDAP Server
screen
displays.
3.
Select
Use Microsoft ActiveDirectory
or
Use OpenLDAP
.
4.
Select the
Authentication method
. For Microsoft ActiveDirectory, the device
supports Simple and Kerberos. For OpenLDAP, the device supports Simple,
Kerberos, and Digest MD5.
5.
Type the
LDAP server location
. (Type an FQDN, such as www.trendmicro.com,
or an IP address.)
6.
Type the
LDAP server port
. (For example, 389.)
