Preconfiguring Network VirusWall Enforcer
4-3
Understanding Preconfiguration
Preparing for Preconfiguration
on page 4-2 have been completed
before starting preconfiguration.
To perform preconfiguration:
1.
Plan and determine the deployment strategy (see
2.
Perform preconfiguration (see instructions in
3.
Perform configuration tasks (see
Configuring Policy Enforcement and Device Settings
in
the
Administrator’s Guide
).
After completing the initial configuration tasks (see
Preparing for Preconfiguration
4-2), use the Preconfiguration console to proceed.
The Preconfiguration Console
The Preconfiguration console lets you configure basic device settings directly using a
keyboard and a monitor. All initial configuration tasks, like specifying port functions and
the device IP address must be done through the Preconfiguration console.
The Preconfiguration console can also be accessed using an SSH client such as PuTTY.
However, before this can be done, you must configure the device IP address and ensure
that the device can connect to the network. For more information on accessing the
Preconfiguration console remotely, see the
Administrator’s Guide
.
Performing Preconfiguration
You must complete the following tasks to preconfigure the device:
1.
Logging on the Preconfiguration Console
2.
3.
Summary of Contents for viruswall enforcer 1500i
