BS/JIG
-5-
Recommended 1/2” x 50mm
straight cutter
Ref. 3/83X1/2TC, 3/83DX1/2TC,
C153X1/2TC, C153DX1/2TC.
Recommended R2.5mm radius
cutter for water drip groove
Ref. C051AX1/2TC
Sub-base Set
Ref. UNIBASE
To obtain a perfect accurate close fitting joint, a
30mm guide bush must be used. The guide
bush must always be fitted concentric with the
cutter. This can be achieved using a Universal
Sub-base and 30mm outside diameter guide
bush ref. GB30.
The Universal Sub-base has a central recess to
allow fitting of the guide bush to most makes of
routers and is available ready to fit the most
popular makes.
The Sub-base contains screws, a line up bush
and two line up pins.The line up pins and bush
ensure exact alignment of Sub-base with router
spindle, when fitted with the relevant collet.
ACCESSORIES
Fits following router models
Atlas Copco OFSE2000 Bosch GOF 1300ACE, 1600A,
1700ACE Casals FT2000VCE DeWalt DW625EK, 629
Draper R1900V Elu MOF 31, 77, 98, 131, 177(E)
Felisatti TP246(E), R346EC Festo OF2000E Freud
FT2000E Hitachi MI12V, M12SA, TR12 Makita 3612BR,
3612(C) Metabo OF1612, OFE1812 Performance Pro
CLM1250R >11/2003, CLM2050R Ryobi RE600N, R600N,
RE601, R500, R502 Skil 1875U1 T-TECH TT/R127
Wadkin R500
General Instructions for Fitting
Sub-bases to Router
1. Fit line up guide bush onto sub-base, with
screws supplied.
2. Fit 12.7mm (
1
/
2
”) shank line up pin into collet
of router. Plunge router until pin projects
through base and lock plunge.
3. Locate guide bush and sub-base assembly
over protruding pin.
4. Line up fixing holes and fit screws.
5. Now tighten up screws.
6. Release plunge, remove line up bush and
line up pin. Alignment should now be correct.
Fit 30mm guide bush and cutter.
7. Periodically check the sub-base is concentric
to the spindle of the router.
C153, C153D, TR17, TR17D, 3/83, 3/83D
Please use only Trend original accessories.
UNIBASE
C051A
MANU/BS v1 25/3/11 16:33 Page 5
