LOCK/JIG
-10-
Fitting the Guide Bush
Fitting Guide Bush to T10/T11 Router
■
If using the Trend T10/T11 Router, fit a 30mm
guide bush Ref.GB30. Make sure the bush is
correctly centred.
Fitting Guide Bush to T5 Router
■
If using the Trend T5 Router, purchase and fit
a GB30.
■
If using the Hinge Jig, fit the GB160 supplied
with the Hinge Jig. By using the Guide Bush
Collar supplied with the Lock Jig, the same
router set-up can be used by simply fitting the
collar in between the hinge and lock
operations.
■
The guide bush collar can be stored on the
spigot fixed to the outside of the clamp bar
when not in use.
Ref. GB160
Ref. GB30
Ref. GB30
Guide bush
collar
Make sure guide bush
collar is fitted with
chamfered edge facing
the jig when parked.
This will make it easier
to remove.
If there is any doubt about the
concentricity of cutter relevant to the
guide bush, then a sub-base should
be used in order to ensure an
accurate fit of face-plate.
Ensure guide bush collar is fitted fully
onto the guide bush with chamfer
facing the jig.
Frequently check that the guide bush
collar is seated properly on the the
guide bush. Check that the collar has
not worked loose otherwise this will
affect the cut.
MANU-LOCK v9.1_MANU-LOCK v9 20/06/2013 09:05 Page 10
