LOCK/JIG
-1-
Dear Customer
Thank you for purchasing this Trend product, we
hope you enjoy many years of creative and
productive use.
Please remember to return your guarantee card
within 28 days of purchase.
CONTENTS
TECHNICAL DATA _____________________1
SAFETY PRECAUTIONS ______________2-3
ITEMS ENCLOSED ____________________4
DESCRIPTION OF PARTS
_______________
5
ACCESSORIES
_______________________
6
- Assembly ___________________________
7
- Setting the Spacers ___________________
7
- Choice of Set-ups - Option 1 ____________
8
- Option 2 ____________________________
9
- Option 3 ____________________________
9
- Fitting the Guide Bush ________________
10
- Steel Templates _____________________
11
- Template Selection Chart ______________
11
- Special Note for Template 11 ___________
11
OPERATION
- Marking Out ________________________
12
- Centring the Jig______________________
13
- Quick Centring for 44mm doors _________
13
- Routing the Mortise___________________
14
- Routing the Face-plate ________________
14
- Finishing ___________________________
15
- Deeper Mortise ______________________
15
- Cutting Key & Spindle Hole ____________
15
MAINTENANCE ______________________15
ENVIRONMENTAL PROTECTION ________15
GUARANTEE ________________________15
SPARE PARTS
- Spare Parts List _____________________
16
- Spare Parts Diagram__________________
IB
☎
If you require further safety advice,
technical information or spare parts,
please call Trend Technical Support
or visit www.trend-uk.com
TECHNICAL DATA
Cutter size
12mm
Min. workpiece
34mm
Max. workpiece
58mm
Template size
59.8mm x 239mm
Largest face plate inner
32mm x 177mm
aperture size
Guide bush size
30mm
Weight
4.5kg
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Refer to the instruction manual of
your power tool.
This unit must not be put into service until it has
been established that the power tool to be
connected to this unit is in compliance with
2006/42/EC (identified by the CE marking on the
power tool).
INTENDED USE
This jig is intended for use with a plunge router
with suitable guide bush and router cutter fitted
to rout a mortise and face plate for locks in
wooden doors.
MANU-LOCK v9.1_MANU-LOCK v9 20/06/2013 09:04 Page 1
