LOCK/JIG
-8-
12mm
Choice of Set-ups
Option
1
+
+
Heavy duty router with
1
⁄
2
”
collet e.g. T10/T11 Router
Router Cutter
Ref. TR37X1/2TC
overall length 115mm
OR USE
Router Cutter
Ref. TR37MX1/2TC
overall length 100mm
with the following
routers:
RYOBI R600, R600(N)
RE601
Makita 3612(C)
Skil 1875U1
30mm Guide
Bush Ref. GB30
See page 8 if a
suitable guide bush
is not available
for your router.
Suitable Plunge Router:
Your router should have following
plunge length:
- For 2” deep locks at least 54mm.
- For 2
1
⁄
2
" deep locks at least
66mm.
- Auger bit and drill required for 3”
deep locks for all routers.
Due to the extra long length of this
cutter, extra care should be taken to
avoid damage. The cutter should be
used to plunge rout a series of
overlapping holes. See page 13.
Fit sufficient length of the shank into
the collet. Ideally at maximum
plunge, only as much of the cutter
should protrude below the base as is
required to reach the depth of the
mortise.
Do not attempt to increase the depth
of cut by having less than the
optimum length of the cutter’s shank
inserted in the collet of your router.
One Spacer required
with T9/T10/T11 router.
The guide bush Ref GB30/A cannot
be used with the jig for internal
doors.
4
MANU-LOCK v9.1_MANU-LOCK v9 20/06/2013 09:05 Page 8
