ENGLISH
1.
Connect one end of a network, phone or USB cable to the Network / Phone
(
RJ45/12
) or USB port on the Transmitter. Connect the other end of the network,
phone or USB cable to the Remote Terminator.
2.
Switch the power button to the
On
position; it will perform a Quick Test by default.
Quick Test Mode
Quick Test mode quickly identifies the type of cable. If a test cable pin out matches
the pin out of a standard cable, the TC-NT3 Transmitter will indicate this by lighting
up the corresponding LED. The default mode on TC-NT3 is set to Quick Test mode.
You can also press the
Test
button 3 times to enter to Quick Test mode.
Note
: Quick Test mode does not include shielded testing. If you would like to test a
shielded cable, please use Auto/Step or Learn mode.
Learn Mode
1
. Before using Learn mode, a known good cable is required.
3
. Power on the TC-NT3. Press the
Mode
button one time or until the Learn mode
LED is lit.
4
. After the cable recording has completed, the
Pass
and
ID
LED will be lit. If the
Fail
LED has lit, Learn mode has failed. Please press the
Mode
button again to
retest the cable until the
Pass
LED is lit.
5
. If a new cable pin out is the same as the learned cable, the TC-NT3 will display
the
Pass
and
ID
LED.
6
. If a new cable pin out is different from the learned cable, the TC-NT3 will display
the
Fail
and
ID
LED.
7
. All stored pin outs in Learn mode will be erased after the TC-NT3 is power off.
Network/Phone and USB Cable Test
3
Learn mode allows the TC-NT3 to memorize and test large quantities of custom
shielded cables with any pin out or configuration. It displays PASS or FAIL.
2
. Connect one end of a cable to the TC-NT3 Transmitter and the other end to the
Remote Terminator.
