ENGLISH
4
Auto Scan Mode/Step Mode
1
. Connect one end of a cable to the TC-NT3 Transmitter and the other end to the
Remote Terminator.
2
. Power on the TC-NT3 then press the Test button once. The AUTO/STEP LED
will blink in to indicate Auto mode. The pin LEDs will indicate pin status.
3
. To change to manual testing, press the
Mode
button once to enter Step mode.
The
Auto/Step
LED becomes solid to indicate Step mode.
4
. Press the
Mode
button again to move to the next pin to test.
Auto Scan mode is used to quickly test pin configurations. Step mode allows you to
manually verify each pin one at a time.
Shield Testing
In Auto/Step mode, it will automatically test for shield integrity. If the shield LEDs
(TX and RX) are lit, the cable is shielded. If the shield RX LED is off, the cable is not
shielded or the shielding has failed.
Coaxial Cable Testing
1
. Use the included RJ45 to F female adapter to test coaxial cable.
2
. The test results will show on pin 4 and pin 5. Pin 4 indicates the center pin and
pin 5 indicates the shield.
Coaxial testing is available for Auto/Step and Learn Mode.
