4.4 Advanced setting
You can change the settings such as ESSID, channel, operational mode and
so on via the advanced setting. To click the “ Setup ”
” Wireless LAN “
“ Operational Settings “ . Regarding the detail setting and parameters, it will
show on the following table. You can assign the proper parameters to this unit
for good performance.
Figure 5
Access Point Name:
The
device name.
ESSID
: Extended Service Set Identifier (Wireless Network Identifier) is
the group name that will be shared by every member of your wireless
network. You will only be able to connect with an Access Point , which
has the same ESS ID.
Channel:
The channel selection. Via the setting to assign the proper
channel for AP.
Fragmentation Threshold:
The parameters of fragmentation.(default
value: 2346)
RTS Threshold:
The parameters of RTS setting.(default value: 2346 )
Authentications Type:
Open System:
Open System is the default authentication algorithm.
Open System authentication is not required to be successful while a STA
10
