2
3. Hardware Installation
Note
: The maximum amount of PoE power available is 15.4 Watts per port and 30 Watts total. If a power
overload has occurred, the switch will prioritize the distribution of power by port (from lowest to highest).
That is, port 1 will receive the highest priority and port 4 will receive the lowest priority. The ports with lower
priority will have their PoE function disabled until more than 7.5 watts of power becomes available.
1
. Plug the power cord into the
Power Adapter
. Connect the
Power Adapter
to the TPE-S44 and then to
a power outlet.
2
. Connect an RJ-45 network cable from the TPE-S44 to your computer's network port.
3
. Connect an RJ-45 cable from a port (1-4) on the TPE-S44 to the
Network
port of the PoE device
(e.g. TV-IP310PI).
4
. Verify the following LEDs are on:
Power
,
PoE Status
and
Link/ACT
.
1
2
POE
3
PoE
