TRENDnet TPL-310AP, Quick Installation Manual

13

Windows Vista

Windows XP/2000

1.

 Go into the 

Control Panel

, click 

Network and Internet

, 

click 

Network and Sharing Center

, click 

Manage 

Network Connections 

and then right-click the 

Local 

Area Connection

 icon and then click 

Properties

.

2.

 Click 

Internet Protocol Version 4(TCP/IPv4)

and then click 

Properties. 

Then click on 

Obtain 

an IP address automatically.

2.

 Click 

Internet Protocol (TCP/IP)

 and then click 

Properties

. Then click on 

Obtain an IP address 

automatically.

1.

 Go into the 

Control Panel

, double-click the 

Network 

Connections

 icon and then right-click the 

Local Area 

Connection

 icon and then click 

Properties

.

4. 

I typed http://192.168.10.100 in my Internet Browser's Address Bar, but an error message says 

“The page cannot be displayed.” How can I get into the TPL-310AP web configuration page?

1. Check your hardware settings again by following the instructions in section 2. 
2. Make sure the 

ETH

 and 

WIFI

 lights are lit. 

3. Make sure the TCP/IP settings are configured properly (see question 1).  
4. Since the Access Point's default IP address is 192.168.10.100, make sure that no other network 

devices are assigned an IP address of 192.168.10.100.  

5. Reset the Access Point. Take a pin or paperclip and press the 

RESET 

button for 5 seconds, 

then let go. Then type http://192.168.10.100 into your browser.

6. If my network's IP is different than the Access Point's range, what should I do?

You should still configure the Access Point first. In Step 9 in section 2: Configure the Access Point, 
select 

Disabled 

for DHCP and change the IP address of the Access Point to match your network's IP 

(e.g. 192.168.2.x, 192.168.0.x).

I have a HomePlug 1.0 or HomePlug Turbo network. Can I use this with my network?

The TPL-310AP is not backwards compatible with HomePlug 1.0 or HomePlug Turbo.

5.