5
10.
You will need to configure the following:
Band
: In most cases, the default setting
(2.4GHz (B+G+N) should be fine.
Mode
: In most cases, the default setting (AP)
should be fine.
Network Type
: This setting does not apply to
(AP) mode. Continue to the next setting.
SSID
: The SSID is the wireless network name
of your wireless network (e.g. wireless router
or access point). Enter a unique SSID
(Network Name). Do not use anything that
would be identifying like “Smith Family
Network”. Choose something that can be
easily identified when searching for available
wireless networks.
Channel Width
: In most cases, the default
Setting (20MHz) should be fine.
Channel Number
: This setting only applies if
the Channel Width is set to 40MHz. In most
cases, the default setting should be fine.
Enable Mac Clone (Single Ethernet Client)
:
In most cases, the default setting should be
fine.
Then click
Next
.
Note:
1. To protect your network from any unauthorized access it is recommended to enable wireless
encryption.
2. Once encryption is enabled on the Wireless Access Point, each wireless computer or device
must be configured with the same encryption key.
3. The example below is for WPA2 (AES) security. If you select WPA or WPA2, make sure your
wireless adapters support WPA or WPA2. If your wireless adapters do not support WPA or
WPA2, then select WEP.
4. For Wi-Fi Protected Setup (WPS) instructions please refer to the User's Guide on the CD-ROM.
WPS instructions will vary depending on your wireless adapter. Please contact the manufacturer
of your wireless
Summary of Contents for TPL-310AP
Page 1: ...Quick Installation Guide TPL 310AP 1 01 ...
Page 19: ......