3.4.11
WPS
This page allows you to configure the settings for Wi-Fi Protected Setup (WPS). Using this feature al-
lows you to connect WPS enabled wireless LAN clients to the wireless access point quickly and easily
with one of the following methods: Virtual Push Button (PBC), Hardware Push Button (Located on phys-
ical device), or PIN number. This feature is only available when the Broadcast SSID is Enabled and using
AP, AP+WDS, or AP+Mesh modes located under Wireless > Basic Settings. WPS can also be used in
Client mode to establish connectivity to another wireless access point or wireless router.
Items
Information
WPS Status
You cannot manually select the items here. The WPS Status will change
from “UnConfigured” to “Configured” after you enable WPS function
and setup a wireless security key for this device.
Self-PIN Number
If you use this device as a client, you can use this code when trying to
connect this device to other AP by using the PIN method.
Push Button
Configuration
Push Button Communication (PBC) method use a simple action of
pushing a button on both the AP and the new STA to reach the function
of easy setup WPS connection. You can simply click the
button in this GUI page. After click on the button, please run the client’s
WPS and push the PBC button within 2 minutes.
Client PIN Number
Personal Identification Number (PIN) method. Users have to fill in the
PIN code of enrollee device and click on the
button to
make communication with other AP. After click on the button, please run
the client’s WPS and push the PIN button within 2 minutes.
*Please click on the
Apply Changes
button or the
Reset
button at the bottom to save/reset the configu-
ration.
