4.
If successful, the Remote Device will have the Device Password listed next to the device
under Password.
Note: If the incorrect Device Password is entered, you will receive an error message. Click
Enter Password
and
try entering the password again.
5.
Repeat steps 1-4 for any remaining Remote Devices.
6.
Once all of the Device Passwords (DPW) are entered into the utility, changes can be applied
to the Remote Devices using the utility.
Change the Network Name/Security Key for multiple adapters using the utility
1.
Click the
Privacy
tab.
2.
Under
Private Network Name
, enter the desired network name/security key and click
Set All
Devices.
3.
At the Network Name Setting prompt window, click
OK.
The current network
name/security key
assignment of the
powerline adapter(s).
Note: If you had
previously used the
Sync button
procedure in
generating a random
network
name/security key.
This will display
“Unknown
Networkname”
Applies changes to Local
Device only.
Note: If you choose this
option, you will
disconnect the Local
Device from the Remote
Devices.
Applies changes to Local Device and
Remote devices.
Note: If you have not entered the
DPW for all remote devices, you will
receive an error and the changes
will not be applied to remote
devices without a DPW.
