Introduction
5
Rear Panel
Figure 3: Rear Panel
Reset Button
This button has two (2) functions:
•
Reboot
. When pressed and released, the TW100-BRF114 will
reboot (restart).
•
Clear All Data
. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1.
Power Off.
2.
Hold the Reset Button down while you Power On.
3.
Keep holding the Reset Button down for five (5) seconds, until
the Red Status LED has flashed TWICE.
4.
Release the Reset Button. The TW100-BRF114 is now using the
factory default values.
WAN port
(10/100BaseT)
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
10/100BaseT
LAN connections
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the TW100-BRF114 will automatically function as
an "Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
Power port
Connect the supplied power adapter here.
6
Chapter 2
Installation
This Chapter covers the physical installation of the TW100-BRF114.
Requirements
•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
•
TCP/IP protocol must be installed on all PCs.
•
For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable
modem (for WAN port usage)
Procedure
Figure 4: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the TW100-BRF114.
Ensure the TW100-BRF114 and the DSL/Cable modem are powered OFF.
2. Connect LAN Cables
•
Use standard LAN cables to connect PCs to the Switching Hub ports on the TW100-
BRF114. Both 10BaseT and 100BaseT connections can be used simultaneously.
•
If required, you can connect any LAN port to another Hub. Any LAN port on the TW100-
BRF114 will automatically function as an "Uplink" port when required. Just connect any
LAN port to a normal port on the other hub, using a standard LAN cable.
2