BXT7059 / BXTS7059 Technical Reference
Advanced
Setup
Serial Port Console Redirection Configuration
The SHB must have an optional IOB33 installed in order for the BIOS setting to apply. Serial port console
redirection is available for use on the IOB33’s COM0 and COM1 serial communication ports. When
selected, the serial port console redirection configuration BIOS screen displays the following parameters.
Option Description
COM0
Console
Redirection
Enabled/ Disabled -- Default setting is
Enabled.
Note: The console redirection
settings shown below will be unavailable if the
Disabled
option is selected.
COM0
Console
Redirection
Settings
Use this setting to specify how the host computer and the remote computer will
exchange data via the COM0 port. Both computers need to have compatible settings.
Here are the available COM0 settings:
Terminal Type:
VT100. VT100+, VT-UTF8, ANSI
Bits per second:
9600, 19200, 38400, 57600, 115200
Data Bits:
7, 8
Parity:
None, Even, Odd, Mark, Space
Stop Bits:
1, 2
Flow Control:
None, Hardware RTS/CTS
VT-UTF8Combo Key Support:
Disabled, Enabled
Recorder Mode:
Disabled, Enabled
Resolution 100x31:
Disabled, Enabled
Legacy OS Redirection:
80x24, 80x25
Putty Keypad:
VT100, LINUX, XTERMR6, SCO, ESCN, VT400
Redirection After BIOS:
Always Enable, BootLoader
COM1
Console
Redirection
Enabled/ Disabled -- Default setting is
Enabled.
Note: The console redirection
settings shown below will be unavailable if the
Disabled
option is selected.
COM1
Console
Redirection
Settings
Use this setting to specify how the host computer and the remote computer will
exchange data via the COM1 port. Both computers need to have compatible settings.
Here are the available COM1 settings:
Out-of-Band Management Port:
COM0, COM1(PCI Bus, DEV0,FUNC0) (Disabled
)
Terminal Type:
VT100. VT100+, VT-UTF8, ANSI
Bits per second:
9600, 19200, 57600, 115200
Flow Control:
None, Hardware RTS/CTS
Data Bits:
Fixed at 8
Parity:
Fixed at None
Stop Bits:
Fixed at 1
Network Stack Configuration
This advanced setup BIOS setting enables or disables the PXE and UEFI network stacks and the default
setting is:
Enabled.
Intel® 82579LM Gigabit Network Configuration – Backplane LAN
Here is where you setup the interface parameters for the Ethernet PHY device that routes a Gigabit LAN
down to the SHB’s edge connector C for use on a PICMG 1.3 LAN-enabled backplane. Listed below are
the available network configuration parameters for the board’s backplane LAN.
Option Description
NIC
Configuration
Link Speed:
AutoNeg
, 10Mbps Half, 10Mbps Full, 100Mbps Half, 100Mbps Full
Wake on LAN:
Enabled
/Disabled (
bold
= default setting)
2-9
Trenton
Systems
Inc.
