TE0600 TRM
Revision: V3.02
Copyright © 2017 Trenz Electronic GmbH
Page
of
19
33
http://www.trenz-electronic.de
Pin Types
Most pins of B2B connectors J1 and J2 are general-purpose, user-defined I/O pins (GPIOs). There are,
however, up to 8 different functional types of pins on the TE0600, as outlined in Table below. In pin-out
tables Table 11 and Table 12, the individual pins are colour-coded according to pin type as in Table below.
TE0600 pin types
type
colour code
description
DIO
Unrestricted, general-purpose differential user-I/O pin.
SIO
Unrestricted, general-purpose user-I/O pin.
CONFIG
Dedicated configuration signals.
PWRMGMT
Control and status signals for the power-saving Suspend mode.
JTAG
Dedicated JTAG signals.
GND
Dedicated ground pin. All must be connected.
TE
Trenz Electronic specific pin type.
See the description of each pin in the user manual for additional information on the corresponding signals.
POW
Power signals.
SPI
SPI signals.
PHY
Ethernet PHY signals.
Note that some of Spartan-6 I/O types are partially compatible, so pins of compatible types can be used as
inputs for signal of other type. For example pins from FPGA bank with 1.5V VCCO (IOSTANDARD =
LVCMOS15) can be used as inputs for 1.2V, 1.8V, 2.5V and 3.3V signals.
See “Spartan-6 FPGA SelectIO Resources” page 38 for detailed information.
