32
3.
Set the On /Off button (1) to “0” to switch off.
Grinding
Scissors:
1. Where necessary, take the scissors apart. This will allow the blades to grind more easily
and safely.
2. Only grind gently with the cutting corner. Work from the wide inner part of the blade out.
Cutting blade:
Grind with both outside knife corners. Work from the wide inner part of the blade out.
Trouble shooting
Problem
Possible cause
Solution
1.Power tool does not start
1.Power supply interrupted
2.Mains power cableor plug
fault
3.Other electrical defect on
power tool
1.Check power by
connecting another power
tool
2.Have checked by
electrician
3.Have checked by
electrician
2.Power tool not operating
at full power
1.Extension cable too long
and/or crosssectiontoo small
2.Power supply (e.g.
generator) voltage too low
1.Use extension cable of
appropriate length and/or
sufficient cross-section
2.Connect power tool to
another power source
3.Insufficient grinding
1.Worn grinding disk
2.Unsuitable grinding disk
used
1.Replace the grinding disk
with a new one
2.Replace the grinding disk
with a suitable one
Accessory
1. Viewing windows with spark deflectors ---------------------------------------------------------2sets
2. Viewing window mounting set---------------------------------------------------------------------2sets
3. Work piece support ----------------------------------------------------------------------------------2pcs
4. Work piece support mounting -------------------------------------------------------------------- 2sets
5. Instruction manual -------------------------------------------------------------------------------------1pc
Summary of Contents for 4673
Page 34: ......
Page 35: ...TBG 200 350 4673 ...
