Trevi Spa User Guide
9
Programming the filtration cycle:
The filter cycle menu includes the
following settings: the start time
(FS)
, the duration
(Fd)
and frequency
(FF)
. A
filter cycle is to start all the pumps and the turbine at high speed for 1 minute
(purging stage) then, the filter pump will run at low speed for the remainder of
the filtration cycle (cleaning step).
The display will show
FSxx
, "xx" representing the filter cycle start time. Use
the
+/-
buttons to adjust the hours. Use the
Filter
button to move to the next
setting, filtration duration
(FD)
.
The display will show
Fdxx
, "xx" represents the duration in hours of the filter
cycle. Use the
+/-
buttons to adjust the duration. Use the
Filter
key to move to
the next setting, the filter frequency
(FF)
.
0 = No filtration
24 = Continuous Filtration
It is not recommended to put the setting to "0".
L'afficheur va montrer
FFxx,
"xx" représentant le nombre de cycles de filtration
par jour. Utilisez les touches
+/-
pour ajuster la fréquence. Utilisez la touche
Filtre
pour passer au paramètre suivant, le mode économie
(EP)
.
Winterizing procedure
Note: Carefully read this entire document before proceeding with the closure of your spa.
In order to avoid unpleasant surprises, please check with your insurance company to make sure that your spa
is insured. If you choose not to make optimum use of your spa and prefer closing it for the winter, we suggest
that you continue to maintain it until the time of closure and have a complete test of your water done in one
of our two superstores or six branches. Keeping the water clean longer helps minimize the accumulation of
dirt and the formation of bacteria, thereby preventing any risk of contamination. To protect equipment against
freezing and to maintain clear water, never turn off the filter system prior to winterizing the spa.
Step 1 : Procedure
▪
First, run pumps and pour 2 cups of bleach into the spa, let the pumps run for one hour. (Warning: pumps
will shut off automatically after 20 minutes, so don’t forget to restart them periodically).
▪
Disconnect the power supply to the pumps, the lights and the ozone generator.
▪
Empty the spa using one of the following methods:
*PM display
Setting the start-up of the
filtration cycle
Setting the duration of the
filtering cycle
Setting the duration of the
filtering cycle
The ‘’Filter cycle’’ display
lights up when the filter is
being operated
.
