14
XF 1300 BEACH
ENGLISH
USING THE MICROPHONE
1. Connect the supplied microphone to the MIC1(2) or MIC2(3) input;
2. Turn on the microphone by turning the switch on the microphone handle to the ON position;
3. Adjust the microphone input volume and the echo effect as desired using the appropriate commands (4/5/6).
TROUBLESHOOTING
If a problem occurs, follow the steps in the table below.
If the problem still can’t be solved, please contact your retailer.
Problem
Possible cause
Solution
No sound when power is
turned ON
1. No input sound source comes
2. Volume knob in the lowest position
3. Voice switch off
4. USB card not plugged
1. Input AUX signal
2. Adjust volume
3. Turn on voice switch
4. Plug USB play MP3
Distorted sound
1. Volume is too loud
2. Audio file error
1. Turn the volume down
2. Check and change the audio file
No sound from the mi-
crophone
1. Microphone socket may not be plugged
properly.
2. Microphone switch may not be on.
3. Microphone volume is on lowest mode.
1. Ensure the microphone is correctly plugged into
the socket.
2. Turn on the microphone
3. Adjust the microphone volume as per users wish
No sound comes after
inserting USB
1. Incorrect file format
2. USB may not be plugged properly
1. File format should be MP3
2. Plug USB correctly
Unable to charge or the
battery works only for
short duration
1. Connect with power cord to charge
2. Battery not fully charged
3. Battery life may have ended
1. Check if power cord connected properly
2. Extend charging time;normally it takes 5-6 hour
to fully charge
3. Replace old batteries with the same specification
as the old batteries.
Speaker makes loud
noises
1. Microphone switched on but may too
close to the speaker
2. Microphone switched on but is not
being used
3. Microphone volume may be too loud
4. Mobile phone is being used too close
to the speaker
5. Other wireless equipment may be
placed very close to the speaker
1. Keep the microphone 2 meters away from the
speaker
2. Turn off microphone if not in use.
3. Adjust microphone volume to lower mode
4. Keep mobile away from the speaker whilst a
ending a call.
5. Keep the speaker away from other wireless
equipment
INFORMATION NOTE ON THE REMOVAL BATTERY
Warning: Only high-qualified personnel should perform this operation!
BATTERY REMOVAL
The appliance should not be plugged to the mains socket when performing this operation!
1. Remove the screws that tighten the rear plastic panel;
2. Remove it and locate the battery;
3. Disconnect the battery and remove it.
INFORMATION ON DISPOSAL BATTERY
Used batteries should not be disposed of with household waste or thrown into fire or water. Used batteries should be recycled or
disposed of in separate waste collection centres.
