12
such as ice, frozen food, cheese rind, bones or fish bones.
At the end of the process, wait for the blade to completely
stop before removing the food from the glass container.
Disconnect the plug from the electrical outlet
immediately after using and / or touching any accessory,
especially the blades. Also, if some food stops the blades,
before removing it, unplug the appliance.
Once finished using the unit, it is recommended to wrap
the power cord so as to ensure a better cleaning avoiding
any risk of damage.
To clean the appliance, it is recommended only using
warm tap water. In case of using detergents, rinse
thoroughly. Do not immerse the motor unit in water or
other liquids; clean it with a damp cloth.
The blades are very sharp: be careful not to cut
yourself when cleaning or while removing food from
the container.
DESCRIPTION G20099
1. Food presser
2. Lid
3. Whipping accessory
4. Support
5. Container
7. Motor gear
8. Motor unit with speed knob
9. Plastic blade
10. Chopping blade
11. 3 stainless steel grating/slicing discs
12. Cap
13. Blender lid
14. Blender jar
SAFETY MODE
This appliance features a double safety device: the unit only works if the container (5) (or the blender jar) is
correctly assembled and stuck on the motor unit (8) and the lid (2) is correctly stuck on top of the container.
FIRST USE
Remove and install the container a few times without plugging it or adding any fruits or
vegetables. Follow these steps to make practice with the object. Wash lids, glass container and accessories in
hot water and detergent. Other accessories with electrical parts, such as
the motor unit, must be cleaned with a damp cloth and dry immediately.
CHOPPING
The knife, consisting of 2 blades, allows to chop
and shred fruits, vegetables, meat and, after having add some liquids, to
prepare baby food.
For a correct use, follow the steps below:
-
Chop fruits and vegetables in pieces before putting them in the glass.
Prepare baby food adding water or milk as you prefer, without
exceeding the max capacity of container.
-
Check that the plug is disconnected from the electrical outlet.
-
Place the container (5) on top of the motor unit (8) and lock it by
turning it clockwise
(operazions 1 and 2).