9
Do not leave the appliance unattended while it is running.
Unplug after each use.
Unplug the unit by pulling the plug and not the power
cord.
Do not immerse product in water or other liquids and
avoid splashing liquids reach the unit.
Before carrying out any cleaning, disconnect the unit
from the electrical outlet.
Before each use, unroll the power cord. Do not insert
anything through the protection grids.
Do not obstruct in any way the protection grids.
Place on solid and stable surfaces and away from
windows or drafts.
DESCRIPTION G50027
1 Front protection grid
2 Fan
3 Rear grid stopper
4 Rear protection grid
5 Drive shaft
6 Motor unit
7 Oscillation pin
8 Inclination pin
9 Main body
10 Control panel
ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1)
Place the rear grid (4) near the plastic motor protection (front part of the motor housing 6) with the metal
handle facing upwards. Fit the holes placed in the central part of the grid with the pins in the plastic and
lock the two parts with the stopper (3).
2)
Insert the fan (2) into the shaft (5).
3)
Remove the screw placed on the front grid (1).
4)
Place the front grid (1) on the rear grid (4), matching the holes on both of them.
5)
Close the locking pins and fasten the two grids tightening the securing screw which it was previously
removed. The fan installation is now complete.
OPERATING
Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using control panel (10) the rotation power can be adjusted on different speeds.
-
0: fan is OFF
-
1: low speed
-
2: high speed
OSCILLATION
The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled.
It is recommended to enable or disable the oscillation of the fan only when the unit is off.
CLEANING
Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
