11
If a multiswitch is installed, follow these steps to
install the supplied 22KHz tone generators.
a.
Disconnect the RF1 cable from the
multiswitch’s “13V” connector.
b.
Connect the RF1 cable to the 22KHz tone
generator’s “LNB” connector.
c.
Connect a supplied RG-179 RF cable from the
22KHz tone generator’s “REC” connector to
the multiswitch’s “13V” connector.
d.
Disconnect the RF2 cable from the
multiswitch’s “18V” connector.
e.
Connect the RF2 cable to the second 22KHz
tone generator’s “LNB” connector.
f.
Connect a supplied RG-179 RF cable from the
second 22KHz tone generator’s “REC”
connector to the multiswitch’s “18V”
connector.
g.
Set the “22KHz OFF/ON” switch on both
22KHz tone generators to the proper position
for the satellite TV service you wish to
receive:
OFF
= DIRECTV, DISH Network, ExpressVu
ON
= DIRECTV Latin America (Galaxy)
h.
Reconnect power to the TracVision system
components.
i.
Turn on the TracVision antenna and
configure it to track satellites that are
compatible with the Tri-Americas LNB.
These include DIRECTV, DISH Network
(EchoStar), ExpressVu, or Galaxy.
Refer to the
TracVision M5/M7 User’s Guide for details.
22KHz Tone
Gener
a
tor
s
S
et
s
witche
s
“ON” for G
a
l
a
xy
Sa
tellite In
Sa
tellite In
Sa
tellite In
Receiver #
3
Receiver #2
Receiver #1
Receiver #4
Sa
tellite In
RF2
RF1
RF2
RF1
AC Power
1
3
V
S
AT
Rx4
ANT
IN
Rx
3
DC
20V
Rx2
Rx1
18V
S
AT
Gro
u
nding Block
(If In
s
t
a
lled)
LNB
REC
LNB
REC
Figure 21: Tone Generator Wiring, Multiswitch Configuration
Installing the Tone Generators
Three or More Receivers
