4
If your TracVision system is currently equipped
with a
Galaxy
or
conventional circular LNB
, you
must first bypass the inverter PCB (see Figure 3).
The following instructions explain how to bypass
the inverter PCB.
a.
Using a 7/16" open-end wrench, disconnect
and remove the RF cable connecting the
inverter PCB to the RF PCB (see Figure 4).
b.
Disconnect the RF cable from the inverter
PCB’s “RF1 TO LNB” connector and connect
it to the RF PCB’s “TO LNB” connector (see
Figure 3: Location of Inverter PCB
Inverter PCB
RF PCB
Behind Cover
Figure 4: Cable Connecting the Inverter PCB to the RF PCB
RF Cable
Figure 5: Moving the RF1 Cable
RF Cable
Bypassing the Inverter PCB
