6
i.
Disconnect the RF cable from the LNB’s RF2
j.
Attach a connector cap
(supplied in the kit)
onto the RF cable you disconnected from the
LNB. Using a tie-wrap
(supplied in the kit)
,
secure the cable to the cable bundle as shown
NOTE:
Leave the other end of this cable connected to
the inverter PCB’s “RF2 TO LNB” connector.
k.
Apply an “RF1” label to the RF cable that is
still connected to the LNB (see Figure 10).
l.
Connect the “RF2”-labeled cable (from step f)
RF Cable
LNB
RF2
Figure 8: RF2 Connector on LNB
Figure 9: Storage Location for Unused RF2 Cable
Tie-wrap
Connector
Cap
RF Cable
Figure 10: RF Connectors on Old LNB
LNB
Continued
Bypassing the Inverter PCB
