10
Two 22KHz tone generators are supplied in the
kitpack. Install these devices in-line with the
antenna’s RF cables as explained below.
If a
multiswitch is installed, skip to page 11.
a.
Disconnect the RF1 cable from the primary
receiver’s “Satellite In” connector.
b.
Connect the RF1 cable to the 22KHz tone
generator’s “LNB” connector.
c.
Connect a supplied RG-179 RF cable from the
22KHz tone generator’s “REC” connector to
the primary receiver’s “Satellite In”
connector.
d.
If you have a second receiver installed, repeat
steps a-c to install the second 22KHz tone
generator between the secondary receiver
and the RF2 cable.
e.
Set the 22KHz tone generator’s “22KHz OFF/
ON” switch to the proper position for the
satellite TV service you wish to receive:
OFF
= DIRECTV, DISH Network, ExpressVu
ON
= DIRECTV Latin America (Galaxy)
If you have two receivers installed, set the switch
on both 22KHz tone generators.
f.
Reconnect power to the TracVision system
components.
g.
Turn on the TracVision antenna and
configure it to track satellites that are
compatible with the Tri-Americas LNB.
These include DIRECTV, DISH Network
(EchoStar), ExpressVu, or Galaxy.
Refer to the
TracVision M5/M7 User’s Guide for details.
Antenn
a
S
econd
a
ry Receiver - Option
a
l
Prim
a
ry Receiver
Thi
s
receiver control
s
sa
tellite
s
election
RF1
RF2
(Option
a
l)
RF1
RF2
(Option
a
l)
22KHz Tone Gener
a
tor
S
et
s
witch “ON” for G
a
l
a
xy
22KHz Tone Gener
a
tor
S
et
s
witch “ON” for G
a
l
a
xy
Gro
u
nding Block
(If In
s
t
a
lled)
Sa
tellite In
Sa
tellite In
LNB
REC
LNB
REC
Figure 20: Tone Generator Wiring
Installing the Tone Generators
One or Two Receivers
