M-1600-2 is a Siphon Sprayer to spray thick heavy material such as truck bed liner material
or for applying thicker coating to a surface that can not be accomplished by a conventional
sprayer.
Assembly Instructions
1. F-C-210-N Air Gun
2. M-1610 Assembly
3. AB-050-4 Spray Wand
4. M-1608 Spray Tips 5/16” Silver(M-1608-S)
You will need…
IMPORTANT
: A pair of safety goggles and an approved respiratory mask
Air Compressor
Air supply hose to run from compressor to F-C-210-N air gun (hose needs 1/4” NPT threads to at-
tach to air gun)
A well ventilated area
To Assemble
1. Attach the sprayhead assembly to the air gun by screwing the swivel nut onto the nozzle end of the
gun
2. Attach the spray wand onto the sprayhead assembly at the discharge end...hand tighten only.
3. Select the desired spray tip and screw it onto the end of the spray wand.
4. Attach a container of material to the sprayhead assembly by screwing the top of the container onto
the aluminum lid.
5. Attach an air hose to the air gun
Operation
IMPORTANT: Follow recommended preparation and safety precautions.
1. Before spraying, make sure that the canister is tightly threaded to the sprayhead assembly, but do
not force!
2. The unit operates between 40-120 psi with an optimum pressure between 70-90 psi.
3. Before changing containers, always disconnect the air hose!
4. Keep the spray wand pointed toward the surface to be sprayed. Never point the spray gun at your-
self or anyone else!
5. Always clean your M-1600-2 after each use.
