20
3-4
PNEUMATIC HOOK-UP
Perform the following steps to hook-up the pneumatic input:
Step I.
Refer to Figure 1-3.
Step 2.
Obtain a 1/4" male air fitting (not supplied with the PORTA-TAC) that
will fit into the sleeve valve located on the right side of the device, and
will mate with the air supply.
NOTE
Recommended fitting is AMFLO #C20 Quick Disconnect with #CP21 Plug or
FOSTER
#3103 Quick Disconnect with #10-3 Plug.
NOTE
The air supply must be 15 CFM at 85 PSIG through a 3/8" ID hose or conduit. A Quick
Disconnect Hose Fitting is RECOMMENDED, as some procedures require the air source
be DISCONNECTED COMPLETELY from the PORTA-TAC.
Step 3.
Install the air fitting.
CAUTIQN
Do not close the sleeve valve at this time
.
3-4.5 ELECTRICAL HOOK-UP
Plug in power pack (110 v/ 220v) to the closest wall outlet.
3-5
INITIAL CHECK-OUT
Perform the following steps to ascertain the pneumatic/ electric system is functioning
properly:
Summary of Contents for PORTA TAC E Series
