8
CONVERSION
Instructions are for conversion from Natural Gas to Propane (L.P.) on all TSGGT & TSGGM models.
The conversion should be done before connecting the unit to the gas supply.
2. Remove the supply tubes that go
between the thermostats and the
orifice bracket
.
1.
Remove the knobs and front panel.
2. Unscrew bolts and pilot valve, then
remove the manifold.
3. Unscrew and remove the orifice
fittings from the valve. Change the
orifices to the size recommended
for propane (L.P.). For units with a
pilot safety valve you must also
change the pilot orifice to the other
pilot orifice supplied.
4. Replace the orifice fittings into the
valve.
5. Replace the front panel and knobs.
6. Before installing the regulator,
unscrew the octagonal cap. With
the brass portion of the cap up, you
can read(NAT) on the plastic insert.
Snap the insert out of the cap, flip it
over and snap back in place. You
can now read(L.P.)
7. Continue with installation.
Regulator with Brass Cap
Note: Unit Number on Side of
Orifice Fittings
Plastic Insert
L.P. Position of Insert
TSGGT
Models
TSGGM
Models
Screw
