TRI TOOL INC.
92-0092 Rev. 210701
14
Check the Bearing, Housing, and the race on the Gear.
All surfaces should be smooth, without scratches, and they should feature even wear
patterns over the entire surface.
Check the Housing cavity for chips, dirt and/or corrosion.
To reassemble, wipe clean all of the Bearing surfaces and clean the Housing cavity.
Regrease the Gear using a lubricant approved by TRI TOOL Inc. Refer to ‘Lubricant
Recommendations’ located later in this section.
Place the Headstock carefully back into the Housing.
Bolt the Front Thrust Plates back into place.
If the bearing pre-load was properly adjusted before disassembly, then it will still be adjusted
when reassembled.
HEADSTOCK
THRUST
PLATE
HOLD-DOWN
SCREWS
MAIN
GEAR
MAIN
BEARING
HOUSING
RACE
HOUSING
CAVITY
THRUST
PLATE
SEVER
LINE
Figure 4: Clamshell Cross Section
Summary of Contents for 601SBM
