37
REPLACING BATTERIES
Sport G3 Transmitter and Beeper
Your product is shipped with one 9-volt battery installed. This battery will last for many months with normal use. If you see the
Transmitter indicator light fail to light up at all or flash rapidly when a button is pressed it is time to replace the transmitter battery.
To change the battery on your Sport G3 Transmitter, unscrew the four Phillips head screws on the back of the transmitter, and lift
off the battery cover to expose the battery compartment.
To change the battery on your Beeper, unscrew the four Phillips head screws on the underside of the Beeper. Slide the battery cover
along the collar strap to expose the battery compartment.
Remove the old battery and install the new battery in the correct direction. Use a Duracell or Eveready 9-volt alkaline battery.
Note that some other brands will be too long and will not fit correctly. Never force a battery into this compartment.
Replace the battery cover and tighten the screws (do not over-tighten).
Check for function by switching the Beeper on, or by pressing a button on the transmitter while you watch the transmitter
indicator light. If there is no function, you may have installed the battery backwards. If so, take it out and switch it around.
Field and Pro Series G3 Transmitter
Your rechargeable Field Series or Pro Series G3 transmitter batteries will last for several years with proper care.
When your transmitter batteries do need replacement you can replace them yourself with a convenient battery pack
obtained from Tri-Tronics. Loosen the two screws and remove the battery compartment door.
Note: the screws are not meant to be removed from the battery compartment door. When removing the compartment
door take care to not damage the gasket between the door and the transmitter body. Remove the battery pack.
Insert the new battery pack, metal tabs facing in and blue foam facing out. Match + and - label on battery
with + and - label on the unit. Replace battery door and tighten screws.