Once the clamp is firlmy in position
tighten bolts to 8Nm with 6mm hex key
Insert handlebar
and align the indicators
for precision alignment
Laser etched
center alignment
indicators
2
1
Insert handlebar & clamp
to the fork using the indicators
for precision alignment
Laser etched
center alignment
indicators
2
1
*Your scooter may vary from those illustrated,
however the assembly procedure is the same
*Do not over tighten any bolts on this scooter.
We recommend you always use a torque wrench
to measure the tightness of each bolt. We
recommend all bolts to be tightened to 10Nm.
Over tightening bolts can result in damaging the
bolt and or part.
Once the clamp is firmly in position
tighten bolts with a 6mm hex key
*Do not over tighten any bolts on this
scooter. We recommend you always use
a torque wrench to measure the tightness
of each bolt. We recommend all bolts to be
tightened to 10Nm. Over tightening bolts can
result in damaging the bolt and or part.
*Your scooter may vary from those illustrated,
however the assembly procedure is the same
Instructional diagram for HIC/IHC
Instructional diagram for SCS
Tightening order - 1,2 with quarter turns,
repeat this process to ensure both bolts are
tightened equally
Tightening order - 1,3,2,4 with quarter turns,
repeat this process to ensure all bolts are
tightened equally
Once the clamp is firmly in position
tighten bolts with a 6mm hex key
