TRIANGLE Industries
- Av. Flandres Dunkerque - Z.I. les Etomelles - F - 02200 Villeneuve Saint Germain
Tél. + 33 3 23 75 38 20 - Fax + 33 3 23 75 38 21 - info@triangle-fr.com - www.triangle-fr.com
6
Recommendations for use
All the speakers are identical. They can be used as rear, front or central channels (the speakers are
magnetically shielded and will not interfere with your television screen).
To position your speakers, follow the rules below for best listening results:
-
Avoid rooms with too much reverberation, such as tiled rooms with no carpets or curtains.
-
Your listening zone should not be too close to the loud speakers: minimum 2m
-
The distance between the main speakers (left and
right
1
) should be a minimum of 2 m for a good
stereo effect.
-
If possible, place the front speakers
1
so that they
"diffuse" along the length of the room.
-
It is recommended to place the rear speakers
2
at
between 1.5 and 2
m in height. They are used to give
atmosphere, the listener should not be able to locate
them. They should not be placed at ear level.
-
The central speaker
3
should be placed near the
television set. For example, place it directly on or
under your television set for optimum coherence with
the image.
-
Place the subwoofer
4
in the front zone for better
sound restitution. However, do not place it against
the television set as the speaker is not shielded. For more information, refer to the
subwoofer manual.
We recommend you configure your satellite speakers in "Small" mode on your A/V amplifier.
You will find further instructions for configuring your installation in the owner's manual for your A/V
amplifier.
Connecting the speakers
Before connecting your installation, make sure all equipment is switched off.
The speakers are equipped with terminals accepting bare wire of diameter maximum 4 mm. We
recommend you carefully strip the end of each wire (on about 1 cm) and insert it into the holes
provided. Connection is made using the terminals, which when screwed, hold the cables tightly.
To prevent the risk of short circuiting, it is important to ensure that no strand of wire is in contact with
the opposite terminal pole. Use the same length of cable for the left and right channels.
