ASSEMBLY INSTRUCTIONS FOR 31741-16
FOR CHAIN-HUNG MOUNTING: (REFER TO FIG.1)
1. Before beginning the assembly, carefully unpack and identify all parts referring to the illustration.
2. Unravel the supply power and ground wires and pass the holes of fixture loop. Thread the fixture
loop onto the coupling at the top of fixture body. Hand tightens until snug.
3. Thread the top of stem into the coupling at the underside of fixture body. Hand tightens until snug.
4. Install proper bulbs (not provided) to the sockets referring to the markings and labels on fixture for
maximum wattage.
5. Locate the tube, cap A, check ring, glass, rubber washer and steel washer. Carefully pass the
center holes of tube, cap, glass, rubber washer and steel washer through the stem and secure
with hex nut.
6. Install cap B through the protruding stem and secure with finial.
7.
Restore power to the installation point ON. Retain this sheet for future reference.
01.06
Page 1 of 2
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
FIG. 1
Fixture loop
Glass
Finial
Cap B
Steel washer
Hex nut
Rubber washer
Check ring
Cap A
Tube
Stem
Fixture body
