ASSEMBLY AND MOUNTING INSTRUCTION
For 31906
Please read the Assembly lnstruction sheet carefully before proceeding.Carefully unpack and
e
identify all parts prior to building the unit. Each part is identified on the drawingfor reference.
DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection and you must returnthe item
for any reason. Please repack the unit using the original carton and inserts.
STEP 1:Unpack all the parts and
Classify them according to the
illustration shown at the side.
Place the parts on a scratchfree
surface;
STEP 2: Make sure the power is
turned Off at the Ceiling junction
box where the fixture is to be
installed.Secure the cross bar to
the ceiling junction using the
junction box screws;
STEP 3: Use the wire nuts to
Connect positive and negative
wires. Connect the Ground wire
to the ground port;
STEP 4: Secure the fixture to the
Ceiling Junction box using two
Brass;
STEP 5: Install the correct bulbs
(not provided);
STEP 6: Install the center rod
washer to the fixture;
STEP 7:install the glass to the glass shade with nut .Secure with bottom cap
and the finial.
Finial
Glass Washer
Nut
Washer
Fixture
