ASSEMBLY AND MOUNTING INSTRUCTION
For 31902
Please read the Assembly lnstruction sheet carefully before proceeding.Carefully unpack and
identify all parts prior to building the unit. Each part is identified on the drawingfor reference.
DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection and you must returnthe item
for any reason. Please repack the unit using the original carton and inserts.
STEP 1:Unpack all the parts and Classify them according to the illustration
shown at the side.Place the parts on a scratch free surface;
Nut
STEP 2:Make sure the power is turned off at the junction box where the fixture is
to be installed.Secure the cross bar to the ceiling junction box using junction box
screws;
STEP 3:Use the wire nuts to connect the
positive and negative wires.Connect the
ground wire to the junction box ground
port;
STEP 4: Secure the canopy to the ceiling
with The knurled ring;
STEP 5: Buckle the quick link to the loop;
STEP 6:Install the loop to the fixture;
STEP 7: Install the center Column to the
Fixture;
STEP 8:Install the correct bulbs(not
provided);
Fixture
STEP 9:install the center rod,washer glass
shade, glass washer and the nut secure
with bottom cap and finial;
Glass Shade
Glass Washer
Washer
