5
Network Cables:
1. Insert the Network cable to be traced, (fitted with an RJ45 plug), into the RJ45
socket on the LAN Cable Identifier Emitter Unit.
2. Turn the Emitter rotary selection switch to “Scan”, the Status LED will flash
indicating that the Emitter is operating normally.
3. Switch on the Receiver Unit by turning the rotary switch clockwise. Use the
probe to detect the far end of the cable being traced. During the test the
Receiver unit will emit a tone to indicate when it is against the cable that is
connected to the Emitter unit.
4. The Receiver Unit can emit two tones, a steady tone and a two-pitch tone. The
preferred tone is selected by pressing the ‘Function button’ on the Emitter Unit.
The volume of the tone can be adjusted using the rotary control on the Receiver
Unit.
Network Wire Location – Typical Applications:
The LAN Cable Identifier can be used to quickly locate the far end of a Network
cable where many cables are present.