- 21 -
CG2CT 860 C
p
hysiCal
l
ayer
p
ipes
/ s
liCes
—> This menu is only displayed if you have selected "T2" or "C2" for
the kind of modulation.
In this menu, you enter the parameter(s)
PLP
(DVB-T2) or
PLP
and
SLICE
(for
DVB-C2), which are required for the selection of the data stream.
DVB-T2
DVB-C2
PLP
0
Bx 4A
PLP/SLICE
0
0
Bx 4A
—> For the reception of DVB-T2 / C2 transponders operating in
"
Mode B
"
(Multiple Input Streams)
, the
Physical Layer Pipe ID
is
needed to select a data stream. If the data streams of a DVB-C2
transponder are also bundled into slices, additionally you need the
Slice ID
to select a data stream.
—> If you can not receive the desired data stream with the default IDs
"0" (e.g. also used at
"Mode A" – Single Input Stream
), ask your
service provider for the corresponding IDs!
• Use buttons
to position the cursor under the digit of the parameters to
be set.
• Press buttons
to set the desired parameter.
• Press the button.
—> The "Input channel / frequency" – "
FREQ
" submenu is activated.
i
nput
Channel
/
freQuenCy
In this menu you set the input channel / input frequency of the transponder you
would like to receive.
FREQ
OK
Bx 2A
/B
C55 746.00
• Use buttons
to position the cursor under the digit of the frequency
resp. channel displayed to be set.