Turn the lid towards
ⶸ
close mark.
Place the juice cup properly.
Assemble the entire top set onto the base. As shown above, assemble the bowl onto the
base and twist the bowl so that the lid edge in pointing to
ⶼ
‘close’ sign.
Assemble the entire juicing unit [Vertical Auger + Juicing Pulp Wiping As
Auger hFeeding Chute Assembly] to the Main Body. Locate the small white arrow on
the rear side of the Auger Housing Lid and set it to meet the arrow at “Open” position on the
rear top of the Main Body.
Turn the Auger Housing clock-wise until the arrow on the Auger Housing Lid aligns to the ar-
row at “Close” position of the Main Body. Make sure the aligning mark at “Close” position on
the Auger Housing lid and the red dot on the Auger Housing are exactly aligned.
Properly place the Juice Container
and Pulp Container at the base of the
juice/pulp spouts.
3
4
How to assemble
Screw
Strainer
Rotation Wiper
Drum Lid
Drum
Assembly position
mark
Juicing bowl
assemble mark
Strainer assemble
mark
Juicing bowl
assemble mark
Place the screw into a center of strainer.
* Spin and push the juicing screw while inserting into
the strainer.
Screw + St Rotation wiper
Make sure
the red dots
are aligned.
By turning it the clock-wise, make sure
the spot
on the lid and
the red spot
on the bowl is aligned.
Connect the lid and the bowl through
the red spot
assembles mark and
assemble it.
Place the Vertical Auger into the center of
the Juicing Screen. Then place the Juicing
Screen into the Pulp Wiping Assembly.
Turn and push down the Juicing Screen
while inserting it into the Pulp Wiping
Assembly.
Insert (Vertical Auger + Juicing Screen
+ Pulp Wiping Assembly) into the Auger
Housing.
Make sure the red dot on the Juicing
Screen and the red dot on the Auger
Housing are aligned.
Vertical Auger
Juicing Screen
Pulp Wiping
Assembly
Red Dot on
Juicing Screen
Red Dot on
Auger Housing
Connect the Feeding Chute Assembly to
the Auger Housing. Align the mark of the
“OPEN” position on the Auger Housing Lid
to the red dot on the Auger housing.
Turn the Feeding Chute Assembly clockwise
until the mark of the “CLOSE” position aligns
to the red dot on the Auger Housing.
Align mark at
“OPEN” position
on the Auger
Housing Lid
Red Dot on
Auger Housing
Auger
Housing Lid
Auger
Housing
HOW TO ASSEMBLE
