Tricity Bendix DH 200, Instruction Book

8

Rinse aid 

Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying. 
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting. 

Filling with rinse aid

1. Open the container by pressing the release button (A). 

2. Add the rinse aid until the container is completely full. The 

maximum level for filling is indicated by "max". 

Ensure that the lid is closed after every refill. 

Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash. 

Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.

Adjusting the dose 

According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position
6 maximum dosage). 

The dose is factory set in
position 4.

Increase the dose if there are
drops of water or lime spots
on the dishes after washing.

Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.

Top up the rinse aid when the indicator light on the control
panel illuminates.

●

If you are using dishwasher detergent that already contains 
rinse aid, it is necessary to deactivate the rinse aid 
dispenser, in order to avoid a double dosage.

Deactivation/activation of the rinse aid
dispenser

(The dishwasher must be switched off)

Factory setting: rinse aid dispenser activated

When the rinse aid dispenser has been deactivated, the
rinse aid indicator light on the control panel is
automatically deactivated.

1. Press the On/Off button. The On/Off indicator light 

illuminates (setting mode).

If a programme button indicator light is on, this means that 
a washing programme has been set. The programme must 
be cancelled: press simultaneously the function buttons 2
and 3 for about 2 seconds. 
All the indicator lights will turn off (except for the On/Off 
indicator light and eventually salt and rinse aid indicator 
lights) indicating that the set programme has been 
cancelled and the machine is now in setting mode.

2. Press simultaneously function buttons 2 and 3, until the 

indicator lights of the function buttons 1, 2 and 3 start 
flashing.

3. Press the function button 2, the indicator lights of function 

buttons 1 and 3 turn off while the indicator light of the 
function button 2 goes on flashing, at the same time the 
indicator light End illuminates indicating that the rinse aid 
dispenser is active.

4. To deactivate the rinse aid dispenser, press the function 

button 2 again, the indicator light End turns off, indicating 
that the rinse aid dispenser has been deactivated.

5. To memorise the operation, switch off the dishwasher by 

pressing the On/Off button or wait about 60 seconds after 
which the dishwasher will automatically return to setting 
mode.

To activate the rinse aid dispenser follow the above
instructions until the indicator light End illuminates.