8
Connect the earth wire to the terminal marked with the
letter 'E' or with the earth symbol.
Connect the live wire to the terminal marked with the
letter 'L' and coloured brown.
Connect the neutral wire to the terminal marked with the
letter 'N' and coloured blue.
Tighten the terminal screws and the cable clamp, then
refit the terminal plate cover.
General Notes
It is recommended that items may be affected by heat
e.g. certain foodstuffs, plastic articles should NOT be
stored above or below the hob unit. This applies to
aerosols which could explode.
The electricity supply, control panel and the wiring
are the responsibility of the installer, but would
normally be wall mounted close to the unit, with the
cable outlet behind the unit housing cabinet.
Enquiries regarding the installation of the electricity
supply should be made to the local Electricity Board
offices, to ensure compliance with their regulations.
ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety
measure not be observed.
Switch OFF
the electricity supply at the mains.
The electrical connection of the ceramic hob to the
specially provided built-in switch box and to the built-in
range should only be carried out by a trained technician.
To wire the hob, carefully place the unit, face downward
on a flat surface with the control area overhanging, to
avoid damage to the controls. Remove the screws
securing the cover to the terminal box, remove the cover
and connect the supply cable via the cable clamp (Fig.4),
to the terminals provided. The cable connecting the
electricity supply to this appliance must have conductors
of sufficiently high cross sectional area to prevent
overheating and degradation. Six square millimetres
(6mm
2
) is the recommended cross sectional area. The
cord should be routed away from potentially hot areas.
Fig.4
You MUST ensure that the cabinet is stable and level.
This appliance complies with EEC Directive number
76/889 and amendment 82/499 relating to the
suppression of radio and TV interference.
Rating Plate
The rating plate is situated on the underside of the unit
and gives the model and serial number of the appliance
(which should be quoted in any communi-cation). It is
advisable to make a note of these in the back of this
instruction book before the appliance is installed.
ATTENTION:
Should a visible crack appear in the
ceramic glass the equipment should be
switched off at the mains and a service
engineer called.
