Z-Wave Remote Control Instructions
TrickleStar Ltd 2008
7
4.3
Device Installation & Set-Up Recommendations
Z-Wave Modules should be plugged-in or hardwired into the location where they will be used.
For best results, do not move or relocate modules after they have been Included into the network. If you wish to re-locate
or move a module from a particular location, first delete it from the network, then include it back to the network after you
have re-located it.
Some Z-Wave Devices only permit a maximum range of 6 ft. between the Remote Control and the Device being Included
as they communicate with low radio transmission power when in their Inclusion mode.
Always make sure that ALL devices to be inserted into a Network have been Reset.
Devices which have already been Included into a network, cannot be Included into a new Network before the have been
Excluded/Reset.
4.4
Including Devices to a Network
1.
Put the Configuration Switch in “Configuration Mode”.
2.
Press-and-hold “Up” Operation button for 2 seconds to enter Configuration Mode. LED Indicator will illuminate
Green.
3.
Short-press the “Up” Operation Button one time to put the device into Inclusion Mode.
4.
Press the Inclusion Initiator of the Device to be Included.
5.
LED Indicator on the Remote will illuminate Green when device is successfully included and illuminate Red if
the operation is unsuccessful.
Repeat steps 2-5 for each Device to be Included to the Network.
Note
: When a Device is Included to the Network it cannot be controlled by the Remote as is must be Associated to the
Remote Operation Buttons.
