19
Version 3.0
5.1 Addressing and grouping
x-touchBOX/PANEL
5 Basic application
5 Basic application
This chapter contains the following topics:
Addressing and grouping
Scenes (S)
Sequences (SQ)
Schedules (SDL)
Schedule list (SDLL)
5.1
Addressing and grouping
To enable communication of x-touchBOX/PANEL with the operating devices, every operating
device of the system must be individually addressed and assigned to a group. Addressing is
performed automatically, grouping must be done manually.
For the subsequent operating devices, the address number is supplemented with the specific
abbreviation. Identification of the components is only displayed if this is supported by the units.
EM
HID
LV
INC
CONF
LED
Somfy
The dialog box
Addressing method
provides two ways of addressing:
System extension
Only newly added operating devices are addressed. The existing addresses remain
unchanged.
Reinitialization
All operating devices of the system are re-addressed. The existing addresses are overwritten.
After automatic addressing, the addresses (1 to 64/128) and, if applicable, specific operating
devices are indicated (e.g. HDI).
Hint
In order to facilitate programming and operating steps, you can assign names to groups, scenes,
sequences and schedules (see "Assigning names", page 16).
PHASED
OUT