23
Version 3.0
5.2 Scene
x-touchBOX/PANEL
5 Basic application
5.2.1
Configuring scenes
In a scene, one of the following settings is made for each group:
Dim
- or -
Off
- or -
Mask
–
One or several groups are defined.
–
The
Main Menu
is displayed.
1. Press the
Scene
button.
= The
S...:
page is displayed.
2. Press the
Folder
button to select the scene in which setting of the groups is to be saved.
= The dialog box
Load scene
is displayed.
3. Use the arrow keys to select the scene (
S1
to
S16
) and confirm with
OK
.
= The scene is displayed.
4. Press the arrow keys of the scroll bar until the desired value is reached to set the dimming
value for the first group.
- or -
Press the
Mask
button so that the settings of the scene do not influence the first group.
- or -
Press the
OFF
button to switch off the first group.
5. Repeat steps 3 to 4 for the three remaining groups.
6. Press the
Save
button.
= The dialog box
Save as scene
is displayed.
7. If necessary, change the scene in which the groups are to be saved and confirm with
OK
.
= The scene is saved.
8. To define further groups for this scene, press the green arrow key and repeat steps 3 to 6 on
the following two pages.
9. To define additional scenes, press the
Folder
button and select a new scene using the arrow
keys. Repeat steps 2 to 7 if necessary.
Hint
To configure a scene, one operating device must only be assigned to one group, because
otherwise conflicts might occur.
Hint
A scene is not saved until you press the
Save
button and confirm the dialog box
Save as scene
with
OK
.
PHASED
OUT