www.tridonic.com
3
Subject to change without notice. Information provided without guarantee.
Data sheet 04/21-CO137-1
Lighting Controls and Connectivity
DALI-2 components
1. Standards
EN 55015
EN 60669-2-1
EN 61000-3-2
EN 61000-3-3
EN 62386-208
EN 62386-101 Ed.2
EN 62386-102 Ed.2
3. Installation
3.1 Safety instructions
• Do not connect the device to DC (direct current) voltage, as this will
damage the device.
• Do not create a short circuit on the secondary side, as this will damage the
device.
It is recommended to connect the device with a residual current circuit
breaker (RCD) or a circuit breaker with a rated value not higher than
10 A to the secondary side to protect the device in case of a
short circuit.
• Installation of this device may only be carried out by specialist staff who
have provided proof of their skills.
• The power supply must be switched off before handling the device.
• The relevant safety and accident prevention regulations must be observed.
• DALI signals are not SELV. Therefore the same procedures should be
applied as working with mains voltage.
1.2 Glow wire test
according to EN 61347-2-11 passed for temperatures up to 750°C.
2. Common
• Loads that do not have a DALI input can be integrated in the DALI circuit.
The loads can be switched on and off via DALI.
3.2 Area of application
The device may only:
• be used for the applications specified,
• for safe installation in dry, clean environment and
• be installed in such a way that access is only possible using a tool.